iVAC Pro Tool Interface
Product Replaced with
The iVAC Pro Tool is used to connect your power tools to an iVAC dust collection control system. Installation is simple – the power tool is connected to the iVAC Pro Tool and the unit is plugged into an electrical outlet. The iVAC Pro Tool takes care of the rest. When the power tool is turned on, the iVAC Pro Tool sends a wireless signal to the iVAC Pro Switch to turn on the dust collector. Similarly, when the tool is turned off, the unit signals the iVAC Pro Switch to turn off the dust collector.
The iVAC Pro Tool is available in a 115V-15A version. Tools with even greater power requirements or 3-phase power can be connected to an iVAC automated dust control system using an iVAC ProTool HP.
Each iVAC Switch can accommodate up to 8 iVAC Pro Tool interfaces.
The range for radio communications between the iVAC Pro Tool Interface and the iVAC Pro Switch is forty feet.
- Programmable Tool and Switch Addresses
- Three Modes of operation – Auto, Off and On
- Wireless operation